UL 62841-3-13 PDF

1 Scope

This clause of Part 1 is applicable, except as follows:

Addition:

This part of IEC 62841 applies to transportable

drills

, with manually fed axial movement of the spindle, having a maximum chuck capacity of 13 mm.

NOTE 101 Transportable

drills

are also known as bench

drills

or

drill

presses.

This part of IEC 62841 does not apply to stationary

drilling

machines.

This part of IEC 62841 does not apply to radial arm

drills

.

This part of IEC 62841 does not apply to magnetic

drill

stands and

drill

motors.

NOTE 102 Magnetic

drill

stands and

drill

motors will be covered by a future part of IEC 62841-3.

NOTE 103 In Europe (EN 62841-3-13), the following conditions apply:

Radial arm

drills

and stationary drilling machines are covered by EN 12717.

Summary of Topics

This revision of ANSI/UL 62841-3-13 dated May 10, 2023 is being issued to update the title page to reflect the most recent designation as a Reaffirmed American National Standard (ANS). No technical changes have been made.

This standard is an adoption of IEC 62841-3-13, Edition 1, published by the IEC February 2017. Please note that the National Difference document incorporates all of the U.S. National Differences for UL 62841-3-13.

As noted in the Commitment for Amendments statement located on the back side of the title page, ULSE and CSA are committed to updating this harmonized standard jointly. However, the revision pages dated May 10, 2023 will not be jointly issued by ULSE and CSA as these revision pages only address UL ANSI approval dates.